OEM Chevrolet Tracker Cruise Control Servo

Chevrolet Tracker Cruise Control Servo Parts and Q&A

• Servo
  30025543
  Q: How to service and repair the cruise control servo on Chevrolet Tracker?

  A:

  Service procedures for cruise control servo start with cruise control module cover removal and loosening the cruise control servo cable locknut. At this stage, perform two actions: disconnect the cruise control servo cable from the cruise control servo assembly then disconnect the electrical connector from the same assembly. Lift out the cruise control servo assembly from the vehicle while removing 3 bolts. Put the cruise control servo assembly back into its position inside the vehicle through the 3 bolts then torque them to 10 N.m (89 lb ft). Reconnect the electrical connector to the cruise control servo assembly after which secure the cruise control servo cable to the cruise control actuator lever. Tighten the cruise control cable locknut to 5 N.m (44 lb in) after you adjust the cruise control servo cable locknuts until a 1-2 mm (0.04-0.08 in) cable play remains at the servo's closed throttle position. Reposition the cruise control module cover as the last installation step.
• Servo
  30025544
  Q: How to replace the cruise control servo on Chevrolet Tracker?

  A:

  Start your cruise control servo replacement by taking off the cruise control module cover then loosening the cruise control servo cable locknut before moving ahead. Separate the cruise control servo cable from the cruise control servo assembly then disconnect the electrical connector. You need to take out the 3 bolts that keep the cruise control servo assembly on the vehicle. Installation involves mounting the cruise control servo assembly to the vehicle by tightening all 3 bolts to 10 N.m (89 lb ft). Rejoin the cruise control servo assembly's electrical connector before installing the cruise control servo cable that runs to the cruise control actuator lever. Adjust both cruise control servo cable locknuts to establish 1-2 mm (0.04-0.08 in) cable play when the throttle is at the closed position before tightening the cruise control cable locknut to 5 N.m (44 lb in). Replace the cruise control module cover as your last step.