OEM Chevrolet Traverse Harmonic Balancer

Chevrolet Traverse Harmonic Balancer Parts Questions & Experts Answers

• Crank Pulley
  12697768
  Q: How to replace the harmonic balancer on Chevrolet Traverse?

  A: The crankshaft balancer replacement process begins with uninstallation of the engine mount strut bracket and the Drive Belt and the Starter. The en 46106 (Flywheel Holding Tool) requires insertion into the Starter mount hole followed by right frame support with jackstands. The technician should remove right side frame reinforcement bolts followed by loosening right side frame bolts while lowering the frame down about 2 inches. Prior to removing the crankshaft balancer bolt, place the j 38416-2 (Crankshaft Button) in the crankshaft nose and use the j 41816 (Crankshaft Balancer Remover) to pull off the crankshaft balancer from the crankshaft. While installing the crankshaft balancer use the j 41998-b (Crankshaft Balancer Installer) and its required components but avoid oiling the seal areas or front oil seal of the crankshaft. Lubricate the internal bore of the crankshaft balancer hub before aligning the balancer with the crankshaft and threading the j 41998-b until it engages at least ten threads before pressing the balancer into position. Screw the j 41998-b until the large washer sits firmly against the crankshaft end before discarding the j 41998-b. At this point, thread in the crankshaft balancer bolt and secure it first to 100 nm (74 lb ft) and complete the process by turning it 150 more degrees using j 45059. Install the Starter after en 46106 removal while using engine support fixtures to raise the engine. Then mount the strut bracket before applying the Drive Belt.