Warranty: This genuine part is guaranteed by GM's
factory warranty.
Fits the following Vehicles:
1996-2000 GMC Savana 2500 | Base, SLE | 6 Cyl 4.3 L GAS, 8 Cyl 5.0 L GAS, 8 Cyl 5.7 L GAS, 8 Cyl 6.5 L DIESEL
GMC Savana 2500 Turn Signal Switch
Our website offers an extensive catalog of genuine GMC Savana 2500 Turn Signal Switch at unbeatable prices. Every OEM GMC Savana 2500 Turn Signal Switch comes with a manufacturer's warranty, an easy return policy, and rapid delivery service. Don't miss out on this great opportunity!
GMC Savana 2500 Turn Signal Switch Parts Questions & Experts Answers
Q: How to replace the Turn Signal Switch on GMC Savana 2500?
A: Start by disabling the SIR system before replacing the Turn Signal Switch. Uncover the trim on both top and bottom sections while you make a note of the steering column wire harness connection to return it later. Disconnect the wire harness assembly from the wire harness strap and take the turn signal and switch assembly out of its connection to the SIR system coil connector. Take both connectors on the turn signal and switch assembly out of its harness plug. Take out the turn signal and switch assembly from the steering column tilt head unit using the two pan head tapping screws. Position the turn signal and switch assembly on top of the steering column tilt head assembly to let its electrical contact touch the turn signal cancel cam assembly. Use the two pan head screws to fix the assembly in place and tighten them until they reach a torque level of 1 N.m (9 lb in). Push the switch connectors of the switch assembly into the bulkhead connections and join one end to the SIR coil following screw tightening to 6 N.m (53 lb in). Position the steering column wires and connector through the new abrasion sleeve as they should extend beyond the middle section smoothly. Put the wire harness assembly into its slot at the harness strap before adding back the trim panels and enabling the SIR system.