Make sure this part fits

GM 89018381
Actuator

2000-2005 Cadillac DeVille

Customer Questions & Expert Answers (8)
GM 89018381 Actuator
GM 89018381 Actuator
  • Part Description
    Actuator, Air Conditioner Control; HVAC Heater Blend Door Actuator
  • Manufacturer
    General Motors
Make sure this part fits
$80.20 MSRP: $164.81
You Save: $84.61 (52%)
Ships in 1-2 Business Days
1
ADD TO CART
  • Vehicle Fitment

    Year Make Model Trim Engine
    2000-2005 Cadillac DeVilleBase, DHS, DTS, Protection Series8 Cyl 4.6 L GAS
    Warning: California's Proposition 65
  • Customer Questions & Expert Answers

    Q:
    Is 89018381 compatible with my car? Posted by ChevyPartsGiant Specialist
    A:
    Please Select Your Vehicle model to see if part number 89018381 is suitable before ordering.
    Posted by ChevyPartsGiant Specialist
    Q:
    How to replace the Blend Door Actuator assembly on Cadillac DeVille? Posted by Customer
    A:
    Start by removing the instrument panel compartment followed by disconnecting the air temperature actuator assembly's electrical connector before continuing with replacement work. To begin the process remove retaining screws and extract the air temperature actuator assembly. Installation preparation requires fitting the passenger air temperature actuator to temperature door shafts to check alignment before actual installation. Use mild damage-free rotation to properly align the shafts before performing a second test fit starting with the inner shaft alignment. Note that adjusting the actuator will cause an out-of-range trouble code to be set up but this code must be deleted after the repair is complete. Automatic re-calibration mode becomes active by connecting the electrical connector to the actuator then holding it away from the shafts then turning the ignition key to on. Find the positions where the temperature door shafts align with the cams during the automatic re-calibration mode then shut off the ignition before testing fit the actuator again. Perform additional cam alignment if needed. Secure the air temperature actuator assembly to the hvac module by following the fastener notice in service precautions. Tighten the retaining screws to 1.4 n.m (12 lb in). After reconnecting the electrical connector to the air temperature actuator assembly and placing the instrument panel storage compartment back in position the system requires an actuator calibration step.
    Posted by ChevyPartsGiant Specialist
    Q:
    What should be done with the rear two DIM module bracket retaining screws for the 2000 Cadillac DeVille? Posted by Customer
    A:
    Install them and tighten to 1.4 N.m (12 lb in).
    Posted by ChevyPartsGiant Specialist
    See expert answers on similar Blend Door Actuator
    Q:
    How do you adjust the cams on the actuator for the 2003 Cadillac DeVille? Posted by Customer
    A:
    Connect the electrical connector to the actuator, hold it away from the shafts, turn the ignition to ON to enter automatic re-calibration mode, observe the cams' motion, and turn the ignition OFF when aligned with the temperature door shafts.
    Posted by ChevyPartsGiant Specialist
    See expert answers on similar Blend Door Actuator
    Q:
    How do you install the driver air mix actuator for the 2001 Cadillac DeVille? Posted by Customer
    A:
    Place the driver air mix actuator back in position and secure it with the retaining fasteners, tightening them to 1.4 N.m (12 lb in).
    Posted by ChevyPartsGiant Specialist
    See expert answers on similar Blend Door Actuator
    Q:
    How should the actuator be secured for the 2004 Cadillac DeVille? Posted by Customer
    A:
    Secure the actuator with the left air temperature retaining screws, tightening them to 1.4 N.m (12 lb in).
    Posted by ChevyPartsGiant Specialist
    See expert answers on similar Blend Door Actuator
    Q:
    How do you adjust the cams on the actuator for the 2005 Cadillac DeVille? Posted by Customer
    A:
    Connect the electrical connector to the actuator, hold it away from the shafts, and turn the ignition to ON to enter automatic re-calibration mode. Observe the cams and turn the ignition OFF when they align with the temperature door shafts.
    Posted by ChevyPartsGiant Specialist
    See expert answers on similar Blend Door Actuator
    Q:
    What is the first step to replace the air temperature actuator assembly for the 2002 Cadillac DeVille? Posted by Customer
    A:
    First, remove the IP compartment and disconnect the electrical connector from the air temperature actuator assembly.
    Posted by ChevyPartsGiant Specialist
    See expert answers on similar Blend Door Actuator
    If you have any questions about this product, please don't hesitate to ask us. We will be happy to help you!

OEM GM Actuator 89018381 Designed for Proper Fit and Performance

Original OEM GM parts deliver superior quality and meet all performance standards needed for optimal automotive operation. The authentic part identified by 89018381 Actuator is available in the market under the name GM Blend Door Actuator. This genuine product has a full warranty coverage from the manufacturer available at all authorized GM dealers throughout the United States. This part 89018381 Actuator fits certain Cadillac DeVille models.
The original GM component designated by manufacturer part number 89018381 maintains top performance when functioning as the Actuator, Air Conditioner Control; HVAC Heater Blend Door Actuator unit. The component 89018381 is constructed from durable material and its dimensions span 9.2 x 8.6 x 3.5 inches while weighing 0.60 Pounds. The Direct Replacement component is ready in New condition to ensure full compatibility with your vehicle system. This component receives the designation of Actuator, A/C Control. The part 89018381 has available replacement options. GM manufacturer provides a warranty that ensures reliable operation of this product. The Shipping Policy and Return Policy pages outline complete details regarding shipping procedures and return processes.
If you want to save money in the long run on maintenance and repairs, you should choose OEM products because they're of the top level of durability. Are you on the quest of finding GM parts, our site is worth a visit. We stock an endless selection of high-quality GM components including things like ignition coils all the way through to fan shrouds and all at prices that can not be matched. You have nothing to worry about because all our OEM parts are covered with a manufacturer warranty, which guarantees superior quality and value.