GM 89019343
Condenser

The necessary tools for condenser replacement in the hvac system begin with the halogen leak detector (J39400-A). Start by taking away the Radiator while also recovering refrigerant from the hvac system. Starting with removal of the receiver dryer followed by the condenser inlet hose bolt and its accompanying inlet hose. After removing the outlet hose bolt first and outlet hose next take off the condenser from its mounts connecting to the Radiator. Refrigerant oil installation follows before new condenser placement enables mounting of the unit onto the Radiator during component migration from the previous condenser. Mount the condenser on the Radiator beforeinstalling its retaining bolts at a torque of 28 n.m (21 lb ft). Secure the receiver dryer onto position first before installing the condenser inlet hose with its bolt and tighten the connection to 20 n.m (15 lb ft). Install the condenser outlet hose with its corresponding bolt followed by bolt tightening to 20 n.m (15 lb ft). The last steps require you to replace the Radiator and perform system evacuations and recharges before running the halogen leak detector (J39400-A) on all fittings.

Start by testing your hvac system's component fittings for leakage using the halogen leak detector (J 39400-A). Start by dissembling the Radiator followed by recovering the refrigerant from the system. Untighten the receiver dryer before you remove it followed by the removal of condenser inlet hose bolt and inlet hose. You should first remove both the condenser outlet hose bolt and the outlet hose. Release the condenser from its mounting points on the Radiator before taking it out in its entirety. Follow the specifications in the refrigerant system capacities to add oil to the new condenser. Mount the new condenser to the Radiator following the transfer of important components from the original condenser unit. Usehand the condenser to its mounts on the Radiator before torquing the retaining bolts to 28 n.m (21 lb ft). Reattach the receiver dryer first and afterward reconnect the condenser inlet hose using its bolt which needs to be tightened to 20 n.m (15 lb ft). Fasten the outlet hose to the condenser while tightening it to 20 n.m (15 lb ft). The last procedure involves installing the Radiator before conducting an evacuation and recharge of the a/c system with proper technique for all operations.

Reinstall the condenser inlet hose and its bolt, tightening to 20 Nm (15 lb ft).

Install the condenser to the radiator and transfer any necessary components from the old condenser.