GM 15911245
Window Regulator, Front Passenger Side

You must remove the front door trim panel together with the water deflector before starting to replace the front side door Window Regulator. Secure the window up against the window frame by using tape before disconnecting it from the Window Regulator carrier plate. Following the removal of electrical components from the regulator motor start by unbolt the motor rail and regulator using a socket wrench before easily extracting the regulator from its key slot within the inner door panel through the hole in the rear. The installation process begins by placing the rear Window Regulator motor and rail bolts a quarter of the way through before inserting the front Window Regulator rail into the rear hole space. Afterward, install the front Window Regulator motor and complete the procedure by screwing in bolts to 11n.m (97 lb in). Attach the front Window Regulator to its key slots on the door inner panel where it also connects to the motor and rail before securing it with bolts at 11n.m (97 lb in). Detach the tape while setting the front window onto the regulator carrier plate before final window attachment. After connecting the electrical connector to the front Window Regulator motor you can install the water deflector and replace the trim panel.

Remove the front window regulator by lifting it up and out from the key slots on the door inner panel through the rear access hole.

Loosen the bolts on both the window regulator motor and the window regulator rail.

Install the window regulator into the key slots, attach it to the motor and rail, and secure it with bolts, tightening them to 11N.m (97 lb in).