GM 22604934
Seat Switch

The front seat bucket should be raised to maximum position before replacing the power seat switch. A flat-bladed tool will remove the bezel covering the switch before you unfasten the cushion cover's J-hook retainer to reach the switch. The process starts with unscrewing the switch bracket followed by removing the switch from inside the seat cushion frame. Remove the electrical connector from the switch's port. First establish electrical connections between the electrical connector and the switch before placing the switch into its position on the seat cushion frame. Drive the switch bracket screw until it reaches 5 N.m (44 lb in) torque. The seat cushion cover should be adjusted for appearance then secured with the J-hook retainer. Press the bezel into place along the switch until it is fully seated before readjusting the seat back to its initial position.

The first step to replace the power seat switch requires raising the front bucket seat to its highest position. Proceed by detaching the bezel from the power seat switch then adjusting the front seat cushion cover to reach inside further. The switch replacement process starts with disconnecting its electrical connector and unscrewing its assembly screws from the power seat switch. Afterward disassemble the seat cushion frame. Begin by connecting the electrical connector to the power seat switch then place the switch on the seat cushion frame before fastening its screws to 3 N.m (27 lb in). After aligning the bezel to the power seat switch position the front seat cushion cover and apply sufficient force until it reaches full seating position. Position the front bucket seat back according to its factory settings.

Connect the electrical connector to the switch.