GM 15205243
Mirror Switch, Rear Driver Side

A worker must first remove two screws that hold the switch plate assembly in position to the door trim panel before starting work. The switch plate front section must be raised to free the clip before you pull out the switch plate from its door trim panel opening. The power switch (3,4) connectors must be detached from their positions on switches (2, 5) before you extract the switch plate assembly from the car body. Replace the switches independently before removing them from the plate while installing only a new switch plate maintain the existing switches for transfer. The switch plate (2, 5) needs to be placed on the switches before securing electrical connectors (3, 4) to (2, 5). Screw in the switch plate assembly to the door trim panel by using the 2 screws while tightening each front door switch plate screw to 2 N.m (18 lb in).

The first step to replace the power mirror switch is to remove the 2 screws which anchor the switch plate assembly onto the door trim panel before lifting the assembly away from the panel. Disconnect the electrical connectors (3, 4) that belong to switches (2, 5) from the equipment and transfer the switch plate assembly off the automobile. Replace the switches from the plate when replacing only switches while keeping the switches for transfer when replacing only the switch plate. You should first install the switches (2, 5) to their respective positions on the switch plate followed by connecting electrical connectors (3, 4) to switches (2, 5). Set the switch plate assembly into the door trim panel by fastening it using two screws while tightening the front door switch plate screws to 2 N.m (18 lb in).