Other Name: Switch, Rear View Mirror; Power Mirror Switch
Position: Rear
Replaces: 10283839
Fits the following Chevrolet Models:
Impala | 2000-2005 | Base, LS, LS Sport, SS | 6 Cyl 3.4 L GAS, 6 Cyl 3.8 L GAS
Monte Carlo | 2000-2005 | LS, LS Competition, LS Sport, LT, SS, SS 35th Anniversary Edition, SS Dale Earnhardt Signature Edition, SS High Sport, SS Pace Car | 6 Cyl 3.4 L GAS, 6 Cyl 3.8 L GAS
Q: How to Change the Mirror Switch on a Chevrolet Malibu?
A: Users should use a flat-bladed tool to release power accessory switch panel retainers by pushing the switch plate from the door trim panel. Break the connection of the electrical connector from the power mirror switch then use a tool to push out the mirror switch from its position in the accessory switch plate. Start the installation by mistakenly installing the power mirror switch into the accessory switch plate then push it in until the retaining tabs lock in position. Connect the electrical connector to the power mirror switch before putting back the power accessory switch plate to the door trim panel while pressing until the retainers fully engage.
Q: How to replace the power mirror switch on Chevrolet S10?
A: Before replacing the power mirror switch the technician must use a flat-bladed tool to free the outside mirror switch retaining tabs on the trim panel before removing the switch and disconnecting the electrical connector from the power folding mirror switch. To install the power folding mirror switch first attach the electrical connector followed by fitting the switch to the door trim panel while applying force to keep the retaining tabs in a fully seated position.
Q: How to replace the power mirror switch on Chevrolet SSR?
A: The first step to replace the power mirror switch requires the removal of the door trim panel. The first step involves letting go of the locking tabs positioned within the door trim panel before you can pull out the power mirror switch bezel . You should start by removing the power mirror switch inside the door then disconnect its electrical connector. Install the new power mirror switch by placing it inside the door trim panel before you install the power mirror bezel properly onto the door trim panel ensuring complete seating. Secure the electrical connector last before replacing the door trim panel.