Q: How to remove and replace the Body Control Module (BCM) on Chevrolet Camaro?
A: The first step to dismantle and install a Body Control Module (BCM) is to disconnect the negative Battery Cable. Detach the ip insulator so you can pull the bcm free from its hvac duct position. Disconnect the electrical connectors that attach to the bcm and reduce the ip harness extension device from the bcm. Secure the ip harness extension to the bcm and join the harness electrical connectors to the bcm. Install the bcm into its position over the duct by pressing it until it seats completely. Replace the i/p insulator at its proper location and connect the Battery Cable while performing any required programming setup.
Q: How to replace the Body Control Module (BCM) on Chevrolet Colorado?
A: Set the Ignition Switch to off position before replacing the Body Control Module. Start your work by taking out the trim panel from the right front hinge pillar. First step unplug the bcm from body wiring at its electric connector and i/p wiring harness electrical connector. Take out the fastener that attaches body wiring harness to bcm and then unscrew the 2 bcm mounting screws which connect to the hinge pillar. Use the unlock option to take out the bcm from its position in the hinge pillar. Set the bcm unit in its place and engage the steel tab with the hinge pillar before installing the two fasteners to secure it. Install the last fastener for the body wiring harness connection. Plug the body wiring harness electronical connector to the bcm and the i/p wiring harness electrical connector to the bcm. Reinsert the right front trim panel into place as the last step. Install the bcm with updated software before putting it into the vehicle.
Q: How to replace the Body Control Module (BCM) on Chevrolet Malibu?
A: Start replacement of the Body Control Module by disconnecting the negative Battery Cable. Start by taking away the right console trim panel parts and unscrewing the bcm device. Unplug the bcm wire harness and take out its unit. The new bcm should first be positioned in place before the bcm wire harness connectors are reconnected following the fastener instructions from service precautions. Install the bcm by fastening screws and tighten them to 2.5 n.m (22 lb in). Place the right console trim back in place and connect the negative battery terminal. Reprogram the new or replaced bcm according to instructions when installing it.