Other Name: Sensor, Computer Control Sensors; Manifold Absolute Pressure Sensor; Air Charge Temperature Sensor; MAP Sensor; Temperature Sensor; Pressure Sensor
Fits the following Chevrolet Models:
Malibu | 2016-2019 | L, LS, LT, RS | 4 Cyl 1.5 L GAS
Q: How to replace the MAP Sensor on Chevrolet Camaro?
A: Begin the replacement of the Manifold Absolute Pressure (MAP) sensor by turning the ignition OFF then disconnecting the electrical connector attached to the MAP sensor. Press on the MAP sensor retaining tabs while gently removing the MAP sensor from the vacuum source before pulling the device straight out. Seek replacement of the MAP sensor seal whenever you find damage during inspection. Through installation procedures ensure the MAP sensor receives its seal properly fitted before installing the sensor to the vacuum source with proper engaging of retaining tabs. Connect the electrical connector for the MAP sensor.
Q: How to Replace a MAP Sensor on Chevrolet Malibu?
A: Start the replacement of the manifold absolute pressure sensor by removing the air cleaner outlet duct before disconnecting the evaporative emission (EVAP) canister purge tube from the Intake Manifold for repositioning out of the way. The worker must first unplug the MAP Sensor electrical connector from the Fuel Injector wiring harness then remove the wiring harness retention clips from fuel rail tabs before disconnecting the harness electrical connector from number 3 Fuel Injector. Press the tabs while sliding the MAP Sensor so you can remove it from its position. Clean engine oil should be used to lubricate the new MAP Sensor seal before you install the MAP Sensor inside the Intake Manifold. Reconnect the Fuel Injector wiring harness electrical connector to number 3 Fuel Injector then install the Fuel Injector wiring harness clips onto the fuel rail tabs followed by reconnecting the Fuel Injector wiring harness electrical connector to the MAP Sensor. Extract the evap canister purge tube from the pathway and then return it to the Intake Manifold before installing the air cleaner outlet duct.
Q: How to replace the MAP Sensor on Chevrolet Impala?
A: Start by taking off the intake manifold cover and cutting the connection of the manifold absolute pressure (MAP) sensor electrical connector. Start by disconnecting the MAP sensor electrical connector . Then if needed remove the spark plug wire clip from the intake manifold bracket and remove the upper intake manifold bolts to extract the MAP sensor along with its bracket and seal from the upper intake manifold. The installation process begins with placing the MAP sensor seal within the upper intake manifold followed by connecting the MAP sensor and bracket. Top manifold bolts must be installed first and tightened to a torque of 25 N.m (18 lb ft). Start by reattaching the spark plug wire clip to the intake manifold bracket after which connect the MAP sensor electrical connector and put back the intake manifold cover.