Q: How to service and repair the Shift Solenoid on Chevrolet Camaro?
A: Service and repair of the Shift Solenoid starts with Transmission Pan along with filter removal as well as the 1-2 accumulator detachment. You must disconnect all electrical connectors attached to the internal harness of the transmission fluid pressure switch and 1-2 shift control solenoid and 2-3 shift control solenoid and pressure control solenoid and tcc pwm solenoid and 3-2 control solenoid. Proceed with removing the pressure control solenoid retainer then extracting the pressure control solenoid from its position. Move the retainers of the 1-2 and 2-3 shift control solenoids before withdrawing these solenoids. The technicians remove the 3-2 control solenoid along with its retainer. You should start by installing the 3-2 control solenoid followed by its retainer before mounting the 1-2 and 2-3 shift solenoids and their retainers. The pressure control solenoid installation requires orientation of electrical tabs toward the outboard position before the addition of the pressure control solenoid retainer and its retaining bolt which should be torqued to 11 nm (97 inch lbs.). Install the Transmission Pan while reconnecting electrical harnesses to the fluid pressure switch and shift control solenoids of 1-2, 2-3, and pressure control solenoids, tcc pwm solenoid, and 3-2 control solenoid.
Q: How to replace the 1-2 Shift Solenoid Valve on Chevrolet Lumina?
A: A proper replacement of the 1-2 shift solenoid valve requires removal of the case side cover and subsequent detachment of transaxle wiring harnesses. Next, remove the 1-2 shift solenoid (315A). Begin by installing the 1-2 shift solenoid (315A) before you reconnect the transaxle wiring harness and complete installation by installing the case side cover.
Q: How to replace the 1-2 Shift Solenoid Valve on Chevrolet Uplander?
A: You must remove the case side cover first before beginning the replacement of the 1-2 shift solenoid valve. Start by disconnecting the transaxle wiring harness followed by the removal of 1-2 shift solenoid (315A). Install the replacement 1-2 shift solenoid (315A) before reattaching the transaxle wiring harness then install the case side cover.