Q: How to replace the spark plug wires for Bank 2 on Chevrolet Camaro?
A: A mechanic should initiate Spark Plug wire replacement for bank 2 by turning off the ignition then securely hoisting the vehicle up. A half-turn twist of the Spark Plug boot unlocks it before you should only pull the boot to protect the wire from damage. Lower the vehicle while disconnecting the plug wires from spark plugs 4 and 6. The number 2 plug wire needs to be removed from the Spark Plug before removing the even (2, 4, 8) Spark Plug Wires from the ignition coils and the Spark Plug wire harness. To install follow these steps: extend the heat shield tabs beneath the hex portion on the Spark Plug. The Spark Plug wire harness installation requires a connection of the even (2, 4, 6) plug wires to each Ignition Coil followed by the number 2 plug wire connection to the Spark Plug. After raising the car, connect plug wires to number 4 and number 6 spark plugs before lowering it down.
Q: How to replace the Spark Plug Wires on Chevrolet Malibu?
A: You need to start the spark plug wire replacement process by twisting each left engine spark plug boot with a half-turn to free it while only pulling on the boot to stop wire damage. After unclipping the Spark Plug Wires from retaining devices it is necessary to remove Spark Plug Wires (1, 3, and 5) plus their retaining clip from engine right side spark plugs. You should first remove all Spark Plug Wires from the ignition coils and the engine. When installing new Spark Plug Wires operators must move all needed components including spark plug wire conduit and retaining clips. Installation process starts with wire-up of Spark Plug Wires between engine components before coil attachment. Secure the Spark Plug Wires numbered 1, 3 and 5 to their corresponding engine right side spark plugs by using the retaining clip. You will complete the installation by placing Spark Plug Wires (2, 4, and 6) on the engine left side spark plugs then fastening them to retaining clips.
Q: How to replace the Spark Plug Wires on Chevrolet SSR?
A: You should start the Spark Plug wire change by taking off the engine sight shield. Twist each Spark Plug wire 1/2 turn and gently pull on the boot to disconnect it from each Spark Plug. You must twist each Spark Plug wire boot one half turn before removing it by pulling on only the boot. Start installation by attaching the Spark Plug Wires to the Ignition Coil before connecting them to each Spark Plug. If you notice loose mounting boots you should check their seating by gently pushing sideways until each boot fits securely. Reinstall the engine sight shield as the final step.