Q: How to service the Power Door Lock Switch on Chevrolet Camaro?
A: Service the power door lock switch through rear-edge prying of the driver-side accessory panel or front-edge prying of the passenger-side accessory panel. Drivers side panel accessories should slide toward the back while passenger side panel accessories should glide toward the front vertex to extract them from the door trim panel. Remove the power door switch elements by first disconnecting the electrical connector from the power door switch then uninstalling the power lock switch from its position inside the accessory panel. During repair connect the electrical connector to the power door switch while placing the power lock switch into the accessory panel. Slide in the front poverty panel edge of the driver side or the back edge of passenger side panel toward the door trim panel and firmly push the rear of driver panel or front of passenger panel to achieve complete installation.
Q: How to Service and Repair the Door Lock Switch in the Driver Door on Chevrolet Colorado?
A: The procedure for replacing the driver door lock switch starts by unscrewing the 2 switch plate assembly retaining screws on the door trim panel followed by lifting the front edge of the switch plate free from its clip to extract it from the panel opening. The electrical connectors (3, 4) should be detached from switches (2, 5) while removing switch plate assembly from the vehicle. Transfer the switches to the new plate if you are handling replacements of only the switch plates or transport all components to the new switch panel regardless of the replacement type. The first step for installation involves setting switch (2, 5) onto switch plate (1) while the electrical connectors (3, 4) should connect with switches (2, 5). The assembly should be installed to the drive trim with two screws while you must tension the front door switch plate screws to 2 Nm (18 lb in).
Q: How to replace the power door lock switch for the passenger front on Chevrolet Malibu?
A: The first task to replace the power door lock switch for the passenger front is the removal of the door trim panel. Start by releasing the tabs then pushing the door switch bezel from the door trim panel before disconnecting the electrical connectors from the door lock switch to remove it from the bezel. You should mount the switch onto the bezel as your first step followed by connecting the electrical wires to the switch. Reposition the door switch bezel onto the door trim and afterward reinstall both the bezel along with the door trim panel.