Other Name: Switch Assembly-Driver Seat Heater; Seat Heater Switch; Switch, Seat Heater; Switch, Front Seat
Position: Driver Side
Replaces: 15878426
Fits the following Chevrolet Models:
Tahoe | 2007-2013 | Hybrid, LS, LT, LTZ | 8 Cyl 4.8 L GAS, 8 Cyl 5.3 L FLEX, 8 Cyl 5.3 L GAS, 8 Cyl 6.0 L FULL HYBRID EV-FLEX (FHEV), 8 Cyl 6.0 L FULL HYBRID EV-GAS (FHEV), 8 Cyl 6.2 L GAS
Q: How to replace the front Seat Heater Switch on Chevrolet Impala?
A: Your first step to replace the front heated seat switch should involve removing the front outer trim panel of the seat cushion in an Impala. The next step involves disconnecting the electrical connector which is located on the front seat wiring harness. A flat-bladed tool will help you remove the retainer clips which allows you to take out the front seat heated seat switch from the front seat cushion outer trim panel. Place the new front seat heated seat switch inside the front seat cushion outer trim panel by applying continuous pressure until the switch reaches total seating position. Replace the front seat wiring harness electrical connector before putting back the front seat cushion outer trim panel.
Q: How to replace the Seat Heater Switch on Chevrolet Malibu?
A: Heated seat switch replacement requires outer trim panel removal from the seat cushions followed by wire harness disconnection from the switch before pulling out the heated seat switch from the trim panel. When installing the heated seat switch you should first put it into the trim panel and then attach the wire harness to the switch with the harness guided through the V-retainer before you replace the outer trim panel on the seat cushions.
Q: How to replace the rear Seat Heater Switch on Chevrolet Silverado 1500?
A: You should begin the heated seat switch replacement task by removing the center console end panel before disconnecting the electrical connection. Starting with the heated seat switch retaining screws the switch should be detached from the vehicle. Position the switch on the console panel before using the retaining screw to secure it according to the Fastener Notice in Service Precautions with a torque of 1.6 N.m (14 lb in). Reinstall the center console end panel after connecting its electrical connector.