Other Name: Switch Assembly-Turn Signal & Headlamp Dimmer; Multi Purpose Switch; Combination Switch; Signal Switch; Switch, Turn Signal Lamp; Switch, Headlamp Dimmer
Replaces: 10362761, 15258881, 15841544, 15915857
Fits the following Chevrolet Models:
Cobalt | 2005-2010 | Base, LS, LT, LTZ, Sport, SS | 4 Cyl 2.0 L GAS, 4 Cyl 2.2 L GAS, 4 Cyl 2.4 L GAS
Equinox | 2007-2009 | LS, LT, LTZ, Sport | 6 Cyl 3.4 L GAS, 6 Cyl 3.6 L GAS
HHR | 2006-2011 | LS, LS Panel, LT, LT Panel, SS, SS Panel | 4 Cyl 2.0 L GAS, 4 Cyl 2.2 L FLEX, 4 Cyl 2.2 L GAS, 4 Cyl 2.4 L FLEX, 4 Cyl 2.4 L GAS
Q: How to service and repair the dimmer switch on Chevrolet Camaro?
A: Service or repair operations for the Dimmer Switch should start with the installation of the Steering Column and j41352 modular column holding fixture (J41352) into a vise clamp. The maintenance process starts by removing the hexagon washer head tapping screw from the Dimmer Switch assembly then taking out the washer head screw from this same assembly. Remove first the Dimmer Switch rod from the Dimmer Switch assembly before proceeding to detach the Dimmer Switch assembly from the Ignition Switch assembly. The end step involves disconnecting the Dimmer Switch assembly from the vehicle's wire harness.
Q: How to replace the instrument panel (I/P) dimmer switch on Chevrolet Classic?
A: The sir system needs disabling before starting the i/p Dimmer Switch replacement process. The instrument panel (I/P) cluster trim plate requires removal from the i/p carrier for access to disconnect the electrical connector from the Hazard Warning Switch if required. As a starting point disconnect the electrical connector from the Dimmer Switch and use a small flat-bladed tool to disengage the retaining tabs of the Dimmer Switch. Pulling on the Dimmer Switch through the front of the i/p cluster trim plate allows its removal. Place the Dimmer Switch inside the i/p cluster trim plate opening before pushing it until it is completely seated. The Hazard Warning Switch electrical connector must connect with the Dimmer Switch and the i/p trim plate needs to lock into its carrier slot. Finally, enable the sir system.
Q: How to properly service and repair the dimmer switch on Chevrolet Malibu?
A: Start the replacement of the dimmer switch by disabling the SIR system. Begin by removing the instrument panel cluster trim plate from the IP carrier then disable the hazard warning switch electrical connector when needed. Detach the electrical connector of the dimmer switch then use a flat-bladed tool to pry open the release tabs. First disconnect the dimmer switch from its position by pressing inward at its edge with one hand holding the instrument panel cluster trim plate. Place the dimmer switch into the instrument panel cluster trim plate then use light pressure to fully engage the internal tabs . If required reconnect the electrical connector to both the hazard warning switch and the dimmer switch. Reinstall the instrument cluster trim plate to IP carrier before turning on the SIR system.