Q: How to replace the Electronic Suspension Control Module on Chevrolet Corvette?
A: Start the Electronic Suspension Control Module replacement by first uplifting the LR floor compartment access lid. Pull the ESC module away from its mounting bracket while keeping it gentle before disconnecting those ESC module connectors. Installation requires ESC module connector connection followed by returning the ESC module into its mounting bracket and then securing the LR floor compartment lid.
Q: How to service the Suspension Control Module on Chevrolet Tahoe?
A: To service the Suspension Control Module you should remove the right side interior trim panel on your vehicle type. Take off the bolt and the electrical connectors from the module. Slide the module out of the bracket and remove it from the vehicle. For installation, slide in the new module into the bracket and wrench the screw (15mm) at 1.6Nm (14 inch lbs). Resolder the module's electrical connectors. In the case of replacing the module, calibrate by connecting the scan tool to the Data Line Connector (DLC) when the ignition is turned ON with the engine OFF, following the scan tool instruction. Lastly, install the right side interior trim panel which is appropriate for the type of your vehicle.