GM 25861557
Window Switch, Driver Side

Replacing the driver side Door Lock as well as side window switch requires starting with front edge switch panel lift to remove the front retaining clip followed by rear edge lifts to release the two rear retaining clips. You must disconnect electrical connectors from the driver door module when provided. You must remove the driver door module from its position in the door trim panel when only performing that part of the replacement. The process of replacement requires disconnecting all remaining electrical connectors from the switch panel. The driver door module needs to stay retained for transfer if a switch panel replacement is performed. Take the switch panel assembly out of the vehicle body. Install the driver door module first onto the door trim panel while connecting its electrical connection to achieve proper setup. When only exchanging the switch panel you should reconnect all other electrical connectors. A proper setup procedure for driver door module programming must be executed after any replacement of the driver door module. Install the switch panel onto the door trim panel while verifying that both front and rear retaining clips are appropriately fit into their respective places.

The first step when replacing the power window switch for the rear door is to pop out the window switch bezel from the door trim panel using a flat screwdriver. Separate the electrical connector from the window switch and detach the holders that fix the power window switch to the bezel before taking off the switch from the bezel. Lay the switch within the bezel, so that all retaining clips are properly engaged and attach the electrical connection to the window switch again. Replace the window switch bezel on the door trim panel by pressing it firmly until both retaining clips click into place.

Disconnect the electrical connector from the quarter window switch and release the tabs that retain the switch to the overhead console.

Connect the remaining electrical connectors.