GM 25846199
Rear Weatherstrip, Passenger Side

The necessary tool needed to replace the rear side access door weather strip is the Door Trim Pad Clip Remover (J 38778). The first step involves opening both the front and rear side access doors. Some elasticity may be required when performing this task. Lead with the Door Trim Pad Clip Remover (J 38778) to free the three integral retaining pins on the mold that secures the upper front molded detail to the side access door. To free the one integral retaining pin on the lower molded front detail of the side access door apply the same Door Trim Pad Clip Remover (J 38778). Install the Door Trim Pad Clip Remover (J 38778) under the weather strip to unlock the integral pins from the door. Conclude weather strip removal by taking it off the side access door opening. Install the weather strip to the rear side access door first and fasten upper molded detail to the front of this door with its built-in retaining pins while the lower molded detail installs with the remaining built-in retaining pins. Install the weather strip around the rear door frame by using integral retainers and then close both the front and rear side access doors.

Reinstall the push pin retainers to the front door sealing weatherstrip at the base of the pillar and close the doors.

Squeeze the weatherstrip together and pull it out of the front door window channel.

Install the endgate weatherstrip lower molds to the vehicle with the integral push-pins.

Lift upward on the forward edge of the sealing strip and remove it from the pinch-weld flange.

Position the weatherstrip to the pinch-weld flange and work down both the right and left sides towards the bottom center, ensuring not to stretch the weatherstrip.

Remove these screws and take out the weatherstrip side retainer from the windshield pillar.

A rubber mallet.

Install the weatherstrip onto the pinch-weld flange, making sure it is fully seated.