OEM 2000 Chevrolet Malibu Oil Filter

2000 Chevrolet Malibu Oil Filter Parts Questions & Experts Answers

• Q: How to service and repair the oil filter adapter on 2000 Chevrolet Malibu?

  A: Service and repair operations for the Oil Filter adapter need to start with raising the vehicle and placing support underneath it. Place the drain pan beneath the engine's oil Drain Plug and remove the plug. Start by cleaning and inspecting the Drain Plug before performing necessary repairs or replacing it when needed. Also inspect the sealing surface on the Oil Pan for repairs or replacement as needed. Start by cleaning the engine block sealing region where the Oil Filter rests before either repairing or replacing this components if needed. Apply a small amount of clean oil to the Oil Filter gasket before installing the new filter by turning it a total of 3/4 - 1 full turn until the gasket makes contact with its mounting surface. Install the engine oil Drain Plug with a torque of 25 nm (18 ft. Lbs.), after which remove the oil drain pan and lower the vehicle down. Start the engine after filling it with new engine oil while inspecting for leakage. Switch off the engine after which you should wait while oil flows back into the Oil Pan for a few minutes. After cleaning the tube end with a towel install the indicator until the handle reaches the tube's top surface. After removing the indicator, verify the oil level by keeping the indicator tip straight down. Use the necessary amount of engine oil by adding or draining from the engine.