OEM 2000 Chevrolet Monte Carlo Wiper Motor

2000 Chevrolet Monte Carlo Parts Questions & Experts Answers

• Q: How to replace the wiper motor on 2000 Chevrolet Monte Carlo?

  A: Acquire the Wiper Transmission Separator Tool (J 39232) and Wiper Transmission Installer Device (J 39529) to perform the wiper motor replacement. Start your work by taking off both wiper arms plus the air inlet grille panel from the vehicle. You should remove the wiper motor connector first and disconnect the wiper transmission from the wiper motor crank using the Wiper Transmission Separator (J 39232). Detach the wiper drive system module by removing three screws and separate its parts from the wiper motor. First remove the rubber boot then loosen the screw before tapping the soft mallet steady to disengage the crank arm. First unscrew three wiper motor screws before taking out the shaft seal and water shield. Begin installation by fitting the water shield and shaft seal on the wiper motor first. Next, fasten the wiper motor to the wiper drive system module through three screws that require 7 N.m (62 lb in) torque. Put the wiper motor crank arm and connect the wiring connector before turning the ignition to ACCY mode, set the wiper switch to PULSE to test how the wiper motor works. Once the wiper motor reaches the inner wipe position switch off the ignition and take off the connector. Attach the wiper motor crank arm into position. Keep 4 to 8 millimeters between the arm and bracket tab while tightening the screw to 16 Newton meters reason. With three screws apply 10 N.m force (88 lb in) and put back the wiper drive system module before installing the wiper transmission on the crank arm using the Wiper Transmission Installer (J 39529). Make sure wiper motor connections work correctly before setting back the wiper arms and air inlet grille and operating the wipers.