OEM 2000 Chevrolet Venture Brake Booster

2000 Chevrolet Venture Brake Booster Parts and Q&A

• Q: How to replace the vacuum brake booster on 2000 Chevrolet Venture?

  A: You must first take out the air cleaner and duct before disconnecting the vacuum hose from the vacuum check valve and putting it at a new spot. Unhook the throttle cables from the Throttle Body and bracket and proceed by removing the heater pipe, fuel lines attached to the pipes and vapor line, abs hydraulic system components, the EGR Tube, cross-exhaust assembly and the transmission fluid filler tube. Before continuing take off the insulator and knee bolster from the driver side while disabling sir features. Rest the Brake Pedal in place to preserve the brake switch when detaching the Brake Booster push rod from the Brake Pedal unit. Separate the Brake Booster from its mounting positions by removing the fastener screws. Install the new Brake Booster on its designated spot between cowl and mounting plate before screwing the Brake Booster mounting nuts to 25 nm (18 ft. Lbs.). Wrap the brake push rod back to its Brake Pedal connection while setting the stoplamp switch correctly. Activate sir then replace the knee bolster along with the left panel insulator, transmission filler tube, exhaust crossover, egr tube, abs hydraulic parts, fuel lines, vapor line, heater pipe, throttle cables, and vacuum hose to check valve. Finish this procedure by placing the air cleaner and duct component parts.