OEM 2001 Chevrolet Monte Carlo Antenna Cable

2001 Chevrolet Monte Carlo Antenna Cable Parts Questions & Experts Answers

• Q: How to replace the antenna cable on 2001 Chevrolet Monte Carlo?

  A: Follow these steps to replace antenna coaxial cable: first detach the rear upper quarter trim panel then disconnect the antenna coaxial cable from the radio antenna module. Proceed by first removing the rear seat cushion followed by the rear seat back then moving to remove the left carpet retainers and the lower center pillar trim panel. Adjust the carpet positioning when accessing the wiring harnesses and take off the left instrument panel insulator. Unplug the antenna coaxial cable from behind the radio before you can obtain radio access. Trim the antenna coaxial cable end extension from the wiring harnesses located both in the kick panel section and in the rear shelf section. New coaxial antenna cables should receive electrical tape installation onto the vehicle yet must maintain contact with the harness at minimum 150 mm (6 in) intervals. You should connect the coaxial Antenna Cable to the radio's rear part before mounting the radio while gripping the sliding snap-lock component to avoid installation problems. Secure the coaxial Antenna Cable from the radio to the kick panel Antenna Cable by positioning it behind the sliding lock feature then installing it to the sliding lock feature. Reassemble the left instrument panel insulator, carpet, lower center pillar trim panel and left carpet retainers. Securely place the coaxial Antenna Cable from the body wiring harness to the coaxial Antenna Cable that rests at the rear shelf area before installing the rear seat back and rear seat cushion. To finish the installation you must join the antenna coaxial cable to the radio antenna module by inserting it behind the sliding lock feature then securing it to the sliding lock feature while executing the final procedure of reattaching the rear upper quarter trim panel.