How to replace brake pads on 2004 GMC Envoy?

Before starting pad replacement work check the brake fluid level is at midpoint between top and bottom marks and drain excess fluid when the level exceeds midway point. Take off the tire and wheel but keep the front caliper clean with denatured alcohol. Position the large c-clamp over the brake caliper pistons to push them into the assembly bore fully. Twist the caliper upward by removing its bottom bolt to work on the brake pads. Take out the brake pads from both sides keeping their shims for disposal. Put on new brake pads by using their supplied retention clips alone. Fasten new retaining clips on the brake pads first and afterwards position the brake caliper with the disks installed. Line up and fit the lower caliper guide pin bolt before tightening it to 40 nm (29 ft. Lbs.). After fitting the wheel and tire back in place return the vehicle to ground level then refill the master cylinder brake fluid until it reaches the right mark. Squeeze the Brake Pedal gently a few times until the pads find their position and keep repeating this if the pedal stays soft. After switching off the engine press down the Brake Pedal two-thirds of its range and let go slowly. Wait for 15 seconds then check if Brake Pedal feels firm enough. Follow up by filling the master cylinder to its required level while finishing the pad break-in process.

OEM 2004 GMC Envoy Brake Pad

Disc Brake Pad Set

Select Vehicle by Model
Select Vehicle by VIN

Select Vehicle by Model

Make

Model

Year

Select Vehicle by VIN

For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).

5 Brake Pads found

View related parts
2004 GMC Envoy Brake Pads Part Number: 89027184
$80.65 MSRP: $151.46
You Save: $70.81 (47%)
Ships in 1-2 Business Days
ADD TO CART
Product Specifications
- Other Name: Pad Kit, Brake; Disc Brake Hardware Kit; Rear Pads
- Position: Rear
- Replaces: 88935809, 88983915
- Item Weight: 3.10 Pounds
- Item Dimensions: 9.5 x 4.1 x 3.1 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 89027184
- Warranty: This genuine part is guaranteed by GM's factory warranty.
More Info
Fits the following 2004 GMC Envoy Submodels:
- Denali, SLE, SLT | 6 Cyl 4.2 L GAS, 8 Cyl 5.3 L GAS
View related parts
2004 GMC Envoy Brake Pads Part Number: 88964424
$81.28 MSRP: $147.14
You Save: $65.86 (45%)
Ships in 1-2 Business Days
ADD TO CART
Product Specifications
- Other Name: Pad Kit, Front Disc Brake; Disc Brake Hardware Kit; Front Pads; Pad Kit, Brake
- Position: Front
- Replaces: 88982932
- Item Weight: 4.30 Pounds
- Item Dimensions: 10.3 x 4.8 x 3.3 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 88964424
- Warranty: This genuine part is guaranteed by GM's factory warranty.
More Info
Fits the following 2004 GMC Envoy Submodels:
- SLE, SLT | 6 Cyl 4.2 L GAS
View related parts
2004 GMC Envoy Rear Pads Part Number: 19122385
Product Specifications
- Other Name: Pad Kit, Brake; Disc Brake Hardware Kit; Brake Pads
- Position: Rear
- Replaced by: 88967051
- Item Weight: 3.30 Pounds
- Item Dimensions: 8.9 x 4.3 x 3.3 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 19122385
- Warranty: This genuine part is guaranteed by GM's factory warranty.
More Info
Fits the following 2004 GMC Envoy Submodels:
- SLE, SLT | 6 Cyl 4.2 L GAS
View related parts
2004 GMC Envoy Brake Pads Part Number: 88967051
Product Specifications
- Other Name: Pad Kit, Brake
- Position: Rear
- Replaces: 88935752, 88983916, 19122385
- Item Weight: 3.30 Pounds
- Item Dimensions: 9.4 x 4.5 x 3.4 inches
- Condition: New
- SKU: 88967051
- Warranty: This genuine part is guaranteed by GM's factory warranty.
More Info
Fits the following 2004 GMC Envoy Submodels:
- SLE, SLT | 6 Cyl 4.2 L GAS
View related parts
2004 GMC Envoy Brake Pads Part Number: 88964423
$88.16 MSRP: $157.44
You Save: $69.28 (44%)
Product Specifications
- Other Name: Pad Kit, Front Disc Brake; Disc Brake Hardware Kit; Front Pads; Pad Kit, Brake
- Position: Front
- Replaces: 12497782
- Item Weight: 4.30 Pounds
- Item Dimensions: 10.2 x 4.9 x 3.4 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 88964423
- Warranty: This genuine part is guaranteed by GM's factory warranty.
More Info
Fits the following 2004 GMC Envoy Submodels:
- SLE, SLT | 6 Cyl 4.2 L GAS

2004 GMC Envoy Brake Pad

With a comprehensive array of OEM 2004 GMC Envoy Brake Pad, from fuel pumps to door handles, our website is a one-stop-shop for your needs. All our genuine 2004 GMC Envoy Brake Pad are backed by the manufacturer's warranty and are offered at competitive prices in the market. Rest assured, you can shop with complete confidence.

2004 GMC Envoy Brake Pad Parts and Q&A

Q: How to replace brake pads on 2004 GMC Envoy?
A: Before starting pad replacement work check the brake fluid level is at midpoint between top and bottom marks and drain excess fluid when the level exceeds midway point. Take off the tire and wheel but keep the front caliper clean with denatured alcohol. Position the large c-clamp over the brake caliper pistons to push them into the assembly bore fully. Twist the caliper upward by removing its bottom bolt to work on the brake pads. Take out the brake pads from both sides keeping their shims for disposal. Put on new brake pads by using their supplied retention clips alone. Fasten new retaining clips on the brake pads first and afterwards position the brake caliper with the disks installed. Line up and fit the lower caliper guide pin bolt before tightening it to 40 nm (29 ft. Lbs.). After fitting the wheel and tire back in place return the vehicle to ground level then refill the master cylinder brake fluid until it reaches the right mark. Squeeze the Brake Pedal gently a few times until the pads find their position and keep repeating this if the pedal stays soft. After switching off the engine press down the Brake Pedal two-thirds of its range and let go slowly. Wait for 15 seconds then check if Brake Pedal feels firm enough. Follow up by filling the master cylinder to its required level while finishing the pad break-in process.