OEM 2005 Chevrolet Cavalier Emblem

2005 Chevrolet Cavalier Emblem Parts Questions & Experts Answers

• Q: How to replace the emblem/nameplate on the rear compartment lid on 2005 Chevrolet Cavalier?

  A: Before replacement you need to apply tape on the mounting surface to protect it and create alignment marks. Using a Heat Gun (J 25070) at 152mm distance and 30 seconds heating time produce circular strokes to warm up the emblem/nameplate. Use plastic and flat plastic tool to take off the emblem/nameplate. 3M(TM) P/N 07501 Scotch Brite molding adhesive remover disk is best for body panels while Varnish Makers and Painters naphtha or a 50/50 isopropyl alcohol and water mixture works well for plastic panels when using a lint-free cloth. Clean the site with a lint-free cloth and the same solution before installation then allow full drying. Section the placement location if required before installation. Position the LS nameplate on the vehicle surface at these positions: 1.688 inches left of the edge with 1.750 inches bottom space. Align it 9.250 inches left from the edge and 1.750 inches bottom space to the LS nameplate. Use the Heat Gun (J 25070) to reach 27-41°C (80-105°F) surface temperature and let the emblem/nameplate warm up to 29-32°C (85-90°F) if needed. To install the part you should avoid handling the sticky surface and place the emblem/nameplate by following the markers while spreading steady pressure across the surface. Take away the protection tape from the designed top area.