OEM 2005 Chevrolet Equinox Brake Light Switch

2005 Chevrolet Equinox Parts Questions & Experts Answers

• Q: How to replace the Brake Light Switch for Cruise Control on 2005 Chevrolet Equinox?

  A: The replacement of cruise control brake switch starts with instrument panel left lower closeout panel removal followed by disconnecting the cruise brake switch connector. Beginning with counterclockwise rotation of the cruise brake switch will liberate it from the switch retainer before pressing down on the Brake Pedal while compressing the locking tabs of the cruise brake retainer to detach it from the Brake Pedal assembly. Position the cruise brake switch retainer into the Brake Pedal assembly upper hole while aligning the retainer arrow at the 3 o'clock angle and extending the retainer ears fully to avoid its detachment. Install the cruise brake switch into its retainer where the electrical connector index notch points to the 1 o'clock direction and push it until the plunger reaches total depression. Continue rotating the switch clockwise to reach the travel stop at around 60 degrees. When installing the switch check that it remains securely in place at the 3 o'clock position with the electrical connector index notch while keeping away from braking the pedal to prevent brake drag conditions. Use a scan tool to check the cruise brake switch in the Engine Control Module (ECM) general information data table which should display correct applied and released states during Brake Pedal depression and release tests. Then reconnect the cruise brake switch harness connector and replace the instrument panel left lower closeout panel.