OEM 2005 Chevrolet Uplander Brake Caliper Bracket

2005 Chevrolet Uplander Brake Caliper Bracket Parts Questions & Experts Answers

• Q: How to replace the rear brake caliper bracket (RPO Codes J5, JL9) on 2005 Chevrolet Uplander?

  A: When working on the rear Brake Caliper Bracket of j5 or jl9 models you need to use mechanic's wire to hold the brake caliper securely. This protects the hydraulic brake hose as you leave it connected. Do not disconnect the hose when removing the brake caliper from its bracket before you take the brake pads off their bracket and the pad retainers out of the bracket as well. Remove the Brake Caliper Bracket bolts as well as the rear Brake Caliper Bracket. Brush away all rust from the caliper bracket using steel wool and check the brake mountings for any signs of damage. Also examine the hardware for wear and tear. Clean and dry threaded holes and caliper bracket bolts by wiping them with denatured alcohol before installation. Apply threadlocker gm p/n 12345493 (Canada 10953488) on 2/3 of the Brake Caliper Bracket bolt length with no gaps between the coating and let it cure for ten minutes. Place the Brake Caliper Bracket first and then fasten the Brake Caliper Bracket bolts until they reach 115 nm (85 ft. Lbs.). Coat the brake caliper pin bolts with high-temp silicone lube and put the Brake Pad retainers and pads onto the Brake Caliper Bracket before installing the caliper.