OEM 2005 GMC Envoy Wiper Arm

2005 GMC Envoy Parts Questions & Experts Answers

• Q: How to Replace the Rear Wiper Arm on an XUV on 2005 GMC Envoy?

  A: The starting point for changing the rear Wiper Arm in the xuv is to pop out the Wiper Arm cover through the small slot under the assembly. Extract the wiper nut before detaching the Wiper Arm from the wiper motor shaft. Disconnect both elements from their shaft. Also remove the rear washer hose from its position. Petroleum jelly-dipped wire brushes scrub the wiper shaft knurls before you take apart the Wiper Arm from the Wiper Arm. Install the Wiper Arm blade onto the Wiper Arm while putting it back into its original position when you removed it. After setting the Wiper Switch to position 3 at run with the engine off, identify the rear wiper Fuse number 9 located underneath the lh rear seat and remove it. After switching off the wiper turn key you must return the Fuse at position 9 to the Fuse box and turn the ignition to lock. Fit the black washer hose onto the end fitting clockwise onto the wiper shaft pivot and join it with the elbow part. Fasten the Wiper Arm at its proper position by aligning the park finger into the park slot of the applique and threading it to 6-10 n.m (55-89 lb in). Fasten the wiper nut cover when you put the engine stop switch in the run position and double-check that the Wiper Arm rests in the applique park pocket during the rear wipe cycle. Before you use the wiper again you must keep the vehicle turned off and the Wiper Arm nut fully tightened. If you turn the engine then you need to start these steps from removing the Fuse again. Review the performance of the endgate window system.