How to replace the Windshield Washer Pump on 2006 Chevrolet Aveo?

Detach the negative Battery Cable at the beginning of the windshield Washer Pump replacement project and observe battery disconnect guidelines. Take out the left front wheel then disconnect the screws that hold the splash shield in place at the front wheel well. Take off both the electrical connection and washing hose before you take out the Washer Pump. Begin the installation by putting in the new Washer Pump then uniting the washer hose and electrical connector. Fuse the front wheel well splash shield back into place using its screws and adjust each screw to 1.5 n.m (13 lb in). After placing the front left wheel back in place you can connect the power cable again.

OEM 2006 Chevrolet Aveo Washer Pump

Windshield Washer Pump

Select Vehicle by Model
Select Vehicle by VIN

Select Vehicle by Model

Make

Model

Year

Select Vehicle by VIN

For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).

1 Washer Pump found

View related parts
2006 Chevrolet Aveo Washer Pump Part Number: 96397517
Product Specifications
- Other Name: Pump, Rear Window Wiper; Washer Pump Repair Kit; Windshield Washer Pump; Pump, Windshield Washer Pump
- Item Weight: 0.50 Pounds
- Item Dimensions: 3.2 x 2.1 x 2.1 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 96397517
- Warranty: This genuine part is guaranteed by GM's factory warranty.
More Info
Fits the following 2006 Chevrolet Aveo Submodels:
- Base, LS, LT, Special Value | 4 Cyl 1.6 L GAS

2006 Chevrolet Aveo Washer Pump

With a comprehensive array of OEM 2006 Chevrolet Aveo Washer Pump, from fuel pumps to door handles, our website is a one-stop-shop for your needs. All our genuine 2006 Chevrolet Aveo Washer Pump are backed by the manufacturer's warranty and are offered at competitive prices in the market. Rest assured, you can shop with complete confidence.

2006 Chevrolet Aveo Washer Pump Parts and Q&A

Q: How to replace the Windshield Washer Pump on 2006 Chevrolet Aveo?
A: Detach the negative Battery Cable at the beginning of the windshield Washer Pump replacement project and observe battery disconnect guidelines. Take out the left front wheel then disconnect the screws that hold the splash shield in place at the front wheel well. Take off both the electrical connection and washing hose before you take out the Washer Pump. Begin the installation by putting in the new Washer Pump then uniting the washer hose and electrical connector. Fuse the front wheel well splash shield back into place using its screws and adjust each screw to 1.5 n.m (13 lb in). After placing the front left wheel back in place you can connect the power cable again.