OEM 2006 Chevrolet SSR Bumper

2006 Chevrolet SSR Bumper Parts Questions & Experts Answers

• Q: How to replace the rear bumper fascia on 2006 Chevrolet SSR?

  A: You should start the process of replacing the rear bumper fascia by lowering the end gate first while opening the rear compartment lid. First remove the rear compartment sill plate and thereafter remove the rear fascia upper fasteners. To proceed with operations start by shutting the end gate under simultaneous removal of retainers from the rear fascia wheelhouse. Before removing the rear fascia from the vehicle you need to detach the rear fascia wiring harness from the body side harness and then remove the center brace support bracket bolt combined with the rear fascia side attaching fasteners. You should install the fascia by aligning it with the body and tighten all rear fascia side attaching fasteners to 6 N.m (53 lb in). The body side harness should receive the rear fascia wiring harness connection while rear wheelhouse retainers must be fitted into the rear fascia which requires tightening wheelhouse fasteners to 6 N.m (53 lb in). Begin by attaching the end gate along with fitting in both the rear fascia upper fasteners. Install the rear compartment sill plate while securing the rear fascia fasteners to 6 N.m (53 lb in). Finish with end gate and rear compartment lid closure afterwards.