OEM 2006 Chevrolet SSR Seat Cushion Pad

2006 Chevrolet SSR Seat Cushion Pad Parts Questions & Experts Answers

• Q: How to remove and replace the front seat cushion pad and cover on 2006 Chevrolet SSR?

  A: The process to replace the front seat cushion cover along with its pad starts by taking out the front seat assembly from the vehicle. The first step requires removing the front finish panel before taking off the seat cushion outer trim panel. After removing the seat switch bezel the next step should be to take out the memory seat control module. Use a tool to detach both the j-strip securing the rear of the cover to the frame together with the push pins that fasten the cover onto the frame. Pull out the seat belt buckle bolt before disconnecting its black electrical connector from the seat belt buckle through the hole in the seat adjuster assembly. First pull the seat belt buckle assembly through the seat cushion cover slot before removing push pins located on the two sides of the seat cushion frame to free the front j-strip. Users should disconnect the seat cushion heating electrical connector before they remove the pad and cover from the frame. The first step is to remove the hog rings which fasten the pad to the cover before you can take off the cover from the pad. Remove the heater element from the pad and guide the heater element electrical harness through the hole found in the pad. To install the equipment begin by routing the electrical harness through the hole in the pad before sticking the adhesive-element to pad contact. Follow the process by first hanging the seat cushion from the frame and afterward securing the seat cover to the pad using hog rings provided for the rod in the cover. Repeat a side-to-side motion when pulling the seat cushion cover over the frame and then connect the seat cushion heater electrical connector before attaching the front j-strip. Fasten the seat cushion cover to the frame structure through push pins then guide the seat belt buckle assembly into the slot before securing the bolt at 55 n.m (41 lb ft). Pass the seat belt buckle electrical harness through the seat adjustment mechanism before plugging in the electrical connector to the seat belt buckle. Use push pins to install the rear seat cover flaps before attaching the j-strip to the frame at the rear of the seat cover. Reinstall the memory seat control module followed by the seat switch bezel and seat cushion outer trim panel and front finish panel and front seat assembly before reinstalling to the vehicle.