OEM 2007 Chevrolet Cobalt ABS Control Module

2007 Chevrolet Cobalt Parts Questions & Experts Answers

• Q: How to replace the ABS Control Module on 2007 Chevrolet Cobalt?

  A: The first step to replacing an ABS Control Module requires setting the ignition switch to OFF because this prevents damage to both the ABS Control Module and EBTCM. The theft body air snorkel should be unbolted before beginning work on vehicles with RPO LSJ. First eliminate all dirt from the surroundings of the ABS Control Module and brake pressure modulator valve (BPMV). Start the ABS Control Module to BPMV replacement by eliminating the four retaining ABS Control Module-to-BPMV bolts then remove the electrical connector from the ABS Control Module unit. When moving the ABS Control Module away from the BPMV use caution without metal tools because they can cause surface scratches. BPMV surface cleaning should be done with denatured alcohol before verifying that the ABS Control Module to BPMV seal has a proper fit. Placing the ABS Control Module in position next to the BPMV electrical terminals allows for connector connection to the ABS Control Module. Secure the 4 ABS Control Module-to-BPMV retaining bolts across each other while tightening them to 4.5 N.m (40 lb in). Installation of the throttle body air snorkel should be completed when RPO LSJ is present. An installation of new ABS Control Module requires programming. Begin by placing the ignition switch at ON position yet keep the engine from starting for Diagnostic System Check - Vehicle. The Control Module References contain all programming and setup instructions.