OEM 2008 Cadillac DTS Antenna Cable

2008 Cadillac DTS Antenna Cable Parts Questions & Experts Answers

• Q: How to replace the digital radio antenna cable on 2008 Cadillac DTS?

  A: First remove the rear sail panel and the rear assist handles while being cautious of the headliner to ensure no damage occurs. Lower the rear of the headliner before you detach the Antenna Cable from its clips to disconnect it from the am/fm Antenna module while removing all foam tape. Hook up a wire segment with string to the radio Antenna connector ends before you detach them. Remove the left rear compartment trim panel followed by disconnecting the Antenna Cable from the digital receiver. Remove the Antenna Cable from its clips and rear harness by pulling it through to the rear compartment where you remove the wire or string. You should install the wire or string by connecting it to your new Antenna Cable before slowly pulling it through the passenger compartment. First disconnect the Antenna Cable from the digital receiver and mount it onto the hold-down clips in the rear compartment. Place the left rear compartment trim panel back in its position before you join the Antenna connectors to the digital radio Antenna along with applying foam tape around the connector. The Antenna Cable needs to be installed above the am/fm Antenna module through locating clips found on the roof and third pillar. Next install the rear assist handles after you fit the headliner correctly to the roof panel.