OEM 2010 Cadillac SRX ABS Control Module

2010 Cadillac SRX Parts Questions & Experts Answers

• Q: How to replace the ABS Control Module on 2010 Cadillac SRX?

  A: Start the ABS Control Module replacement project by turning off the ignition switch because this prevents ABS Control Module/EBTCM damage. You should first remove and set aside the surge tank of your radiator but maintain the coolant inside and leave the hoses attached. The ABS Control Module and BPMV require cleaning from any loose dirt after you free the master cylinder heat shield by taking off its bolts and nuts. Tear down the ABS Control Module electrical connector before removing ABS Control Module bolts. Avoid prying apart components and extract the ABS Control Module from the BPMV while removing 12 ABS Control Module seals as needed. Begin by installing the new ABS Control Module seals followed by attaching the ABS Control Module onto the BPMV while tightening its bolts in a cross pattern to 3 Nm (27 lb in). The master cylinder heat shield requires installation if applicable using the bolt with a torque of 10 Nm (89 lb in) and the nuts with 25 Nm (18 lb ft) torque. Installation of the radiator surge tank must be completed following the reinstallation of the ABS Control Module when a new ABS Control Module unit is present. Conclude the procedure through execution of the Diagnostic System Check - Vehicle.