OEM 2010 Chevrolet HHR Flywheel

2010 Chevrolet HHR Flywheel Parts Questions & Experts Answers

• Q: How to replace the engine flywheel on 2010 Chevrolet HHR?

  A: The first step when replacing an engine Flywheel requires removal of either the transaxle if using automatic transmission or clutch if using a manual transmission setup. Position the j 38122-a next to the crankshaft balancer and cut off the chamfer at the 18mm socket edge to gain full grip on thin Flywheel bolts. Discard automatic transaxle Flywheel bolts before you remove the Flywheel while ensure that the manual transaxle is cleaned up next if applicable and avoid orientating the Flywheel to the crankshaft because it will undergo separate balancing procedures. A nylon bristle brush should be used to remove all thread adhesive from the Flywheel bolt holes. Mount and tighten the new manual transaxle Flywheel using j 45059 to 53 nm (39 lb ft) torque specification along with 25 additional degrees of engagement. Install and secure the automatic transaxle Flywheel using new automatic transaxle Flywheel bolts according to the specified torque of 53 nm (39 lb ft) with j 45059 tool while performing an additional 25-degree angle. The j 38122-a tool needs removal before reinstallation of the clutch when using manual transmission or the replacement of the transaxle component with automatic transmission.