How to replace the ABS Control Module on 2010 GMC Canyon?

Begin ABS Control Module replacement by switching off the ignition stem. Break loose and remove both the brake pressure modulator valve (BPMV) and then remove the ABS Control Module bolts. Throw out the discarded hardware. The ABS Control Module must be properly disentangled from the BPMV before you remove all 12 ABS Control Module to BPMV seals. Presentation of the ABS Control Module along with its 12 seals onto the BPMV requires attention when installation begins because all ABS Control Module bolts need replacement with new ones which should be tightened to 2 Nm (18 lb in). Install the entire ABS Control Module/BPMV assembly into the vehicle before performing an ABS Control Module programming procedure when needed.

OEM 2010 GMC Canyon ABS Control Module

Anti Lock Brake Control Module

Select Vehicle by Model
Select Vehicle by VIN

Select Vehicle by Model

Make

Model

Year

Select Vehicle by VIN

For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).

1 ABS Control Module found

View related parts
2010 GMC Canyon Control Module Part Number: 19207520
Product Specifications
- Other Name: Module Kit, Electronic Brake Control; ABS Control Module
- Item Weight: 3.20 Pounds
- Item Dimensions: 7.4 x 7.3 x 6.2 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 19207520
- Warranty: This genuine part is guaranteed by GM's factory warranty.
More Info
Fits the following 2010 GMC Canyon Submodels:
- SLE, SLT, WT | 4 Cyl 2.9 L GAS, 5 Cyl 3.7 L GAS, 8 Cyl 5.3 L GAS

2010 GMC Canyon ABS Control Module

With a comprehensive array of OEM 2010 GMC Canyon ABS Control Module, from fuel pumps to door handles, our website is a one-stop-shop for your needs. All our genuine 2010 GMC Canyon ABS Control Module are backed by the manufacturer's warranty and are offered at competitive prices in the market. Rest assured, you can shop with complete confidence.

2010 GMC Canyon ABS Control Module Parts and Q&A

Q: How to replace the ABS Control Module on 2010 GMC Canyon?
A: Begin ABS Control Module replacement by switching off the ignition stem. Break loose and remove both the brake pressure modulator valve (BPMV) and then remove the ABS Control Module bolts. Throw out the discarded hardware. The ABS Control Module must be properly disentangled from the BPMV before you remove all 12 ABS Control Module to BPMV seals. Presentation of the ABS Control Module along with its 12 seals onto the BPMV requires attention when installation begins because all ABS Control Module bolts need replacement with new ones which should be tightened to 2 Nm (18 lb in). Install the entire ABS Control Module/BPMV assembly into the vehicle before performing an ABS Control Module programming procedure when needed.