OEM Cadillac Escalade ESV Timing Chain

Cadillac Escalade ESV Timing Chain Parts Questions & Experts Answers

• Timing Chain
  12646386
  Q: How to replace the timing chain, crankshaft sprocket, camshaft position actuator, and solenoid valve on Cadillac Escalade ESV?

  A:

  In order to replace the Timing Chain, crankshaft sprocket camshaft position actuator and solenoid valve, an ignition pump must be removed first. Make sure that the teeth of the j 42386-a are in the right position. Rotate the crankshaft sprocket until the camshaft position (CMP) actuator alignment mark and the crankshaft sprocket alignment mark are aligned and install and tighten the j 42386-a remove and discard cmp actuator solenoid valve (234) loosen and separate from the cmp actuator & Timing Chain the camshaft, be careful not to pull on the reluctor wheel. Dismount the cmp actuator (235) and Timing Chain (208), and put a tie strap through the center of the actuator and over the reluctor wheel, then unbolt the Timing Chain tension bolts (231) and tensioner (232). Now use the j 41816-2, j 41558, bolts, and j 8433 to undo the crankshaft sprocket, (207), and also the crankshaft sprocket key if any. For installation, insert the key in crankshaft key way tap it and fit the crankshaft sprocket on the crankshaft and align the key with the sprocket keyway. Install the crankshaft sprocket using the j4178 and j41665 until seated. Compress the Timing Chain Tensioner guide and install the en 46330 and install the Timing Chain Tensioner (232) and bolts (231) with a torque of 25 nm (18 lb ft). Correctly attach the cmp actuator to the location pin of the camshaft to make sure the teeth on the sprocket interfacing with the teeth of the Timing Chain align well, as well as the marking alignment marks. Mount the cmp actuator (235) and Timing Chain (208), and guard the hole in the cmp actuator against the locating pin in the camshaft. Do not attempt to push or pull the reluctor wheel when placing into the hole. Make sure the actuator is fully seated, check at the proper installation, and install a new cmp actuator valve (234), tight it by hand until it is snug. Check the alignment of sprockets, remove the en 46330, and tighten cmp actuator bolt initially to 65 nm (48 lb ft) and then further 90 degrees with j 45059. Finally, remove the j 42386-a and replace install Oil Pump.