OEM Cadillac Escalade EXT Oil Pan

Cadillac Escalade EXT Oil Pan Parts Questions & Experts Answers

• Oil Pan
  12579273
  Q: How to replace the oil pan on Cadillac Escalade EXT?

  A: Initially, in case it has four wheel drive (4WD) then you should remove its inner axle housing nuts and washers from the bracket, then you should use a suitable jack to support its front drive axle. Next demount the tier differential lower and upper mounting and the bolts, nuts, lower the front drive axle, and demount the transmission cover bolt. Remove, if needed, bolts that attach the Oil Pan skid plate and the skid plate, as well as the bolts attaching the crossbar and the crossbar. Take off the transmission cover bolt and cover, drain the engine oil and remove the engine Oil Filter and then return the drain plug and Oil Filter until it is tight. If there is a vehicle using the 4l60-e automatic transmission, one should remove the transmission bolt and stud on the right side and the bottom left one. If you have 4l80-e automatic transmission, take out the cover bolts of the converter. Unplug the oil level sensor electrical connector, remove the Battery Cable channel bolt, and slide the channel pin out of the Oil Pan tab, remove the engine wiring harness clip, positive Battery Cable clip, and engine oil cooler lines from the positive Battery Cable clip, also remove positive Battery Cable clip bolt and clip. Unscrew all the bolts of the Oil Pan and the Oil Pan itself, whilst making sure no foreign object gets into the oil paths. Drill out the Oil Pan o. G. Retaining rivets if necessary, and then remove and discard the gasket and rivets. Check the engine Oil Pan for any cleaning and perform an inspection as necessary. For installation, apply a beaed of sealant gm p/n 12378190 er equivalent to the engine block ont he tabs o the front and rearower cover gcxkets that extend into the Oil Pan surface. Arrange the oil gallery passages in the Oil Pan and engine block correctly with the new gasket then fasten the gasket onto the pan and the bolts through the area of the gasket. Install the Oil Pan along with the gasket and bolts to the engine block ensuring the Oil Pan bolts are screwed in without overtightening them. If the vehicle has the 4l80-e transmission, tighten the transmission converter cover bolts loosely. For automatic transmission 4l60-e, before snugging the bolt down to a transmission bolt, attached on the right side as well as the bottom bolt is the left side. Tighten the Oil Pan and Oil Pan-to Oil Pan front cover bolts to 25 nm (18 ft. Lbs), Oil Pan-to-rear cover bolts to 12 nm (106 inch lbs), and the bellhousing,converter cover, and the transmission bolts/stud to 50 nm (37 ft lbs). Install the positive Battery Cable clip and bolt to the Oil Pan tighten bolt to 9 nm (80 inch lbs) and install the engine oil cooler lines then to the positive Battery Cable clip then the engine wiring harness clip and positive Battery Cable clip. Slide the channel pin into the tab of Oil Pan, install the Battery Cable channel bolt and tighten 12 nm (106 inch lbs.). Connect the oil level sensor electrical connector , install the transmission cover and bolt, tighten bolt 12 nm (106 inch lbs.) , and then install the crossbar and tighten the crossbar bolts to 100 nm (74 ft. Lbs.). If available, mount and tighten the oil skid pan plate with its bolts at 20 nm (15 ft. Lbs.), then the transmission cover bolts at 12 nm (106 inch lbs.). Lift the front drive axle to position and install the differential carrier upper bolt and nut to tight without installing, and then install the differential carrier lower bolt and nut and tighten to 100nm (75 ft. Lbs.). Finally install the inner axle housing washers and nuts to bracket, torque to 100 nm (75 ft. Lbs.), remove the jack from the front drive axle, and install a new engine oil and a new Oil Filter.