To change the front Torsion Bar, first, lift and support the vehicle, that would allow the front suspension to come to the rebound position. Mark the adjuster bolt and indicate via the number of turns required to remove it for reassembly. Removing the adjuster bolt, spacer, and adjuster nut with an observation that the torsion bars are unique for the left and right side of the vehicle. Then, take out the adjustment arms and torsion bars in one as a piece by displacing their rear end to separate them from the lower Control Arm. For installation, place the adjustment arms and torsion bars according to the original positioning, attach the adjustment arm at the Torsion Bar and slide the Torsion Bar towards the lower Control Arm till it is fully engaged. Contact muffler will stay the same without a change in position. Tighten the adjuster bolt slightly while the adjuster nut is on the opposite end. Replace the two degas tank fittings with straight tube ends (dealer). tighten the bolt to 55 nm (40 ft lb). Using a wrench, spin the spacer and adjuster bolt washer off the adjuster.istrov then remove the tip. Then remove the tip top nut.