Open the hood, lift and support the vehicle and remove the tire and wheel to start servicing the wss. After that, remove the brake rotor (2) and the wss mounting bolt and then uninstall the Wheel Speed Sensor (5) from the hub/bearing assembly (4). Disconnect the mounting clips for the wss cable from the knuckle, upper
Control Arm and onto the frame. After that, take out the wss electrical cable connection as well. Put the wss (5) back into the hub/bearing assembly (4) and hold it in place with the mounting bolt, tightening it to 18 n.m (13 lb ft). Fix the wss cable mounting clips to the knuckle, upper Control Arm and frame location next and install the electrical connector where the wss cable is attached. At last, fit in the brake rotor (2) and reinstall the tire and wheel.