Other Name: Fuse, Wiring Harness *Yellow; Fuse; Fuse, Main Wiring Junction And Fuse Block; Fuse, Chassis Electrical; Fuse, Wiring Junction; Fuse, Fuse
Warranty: This genuine part is guaranteed by GM's
factory warranty.
Fits the following Vehicles:
2014-2023 Chevrolet Silverado 1500 | Custom, Custom Trail Boss, High Country, LS, LT, LT Trail Boss, LTZ, PPV, RST, SSV, WT, ZR2 | 4 Cyl 2.7 L GAS, 6 Cyl 3.0 L DIESEL, 6 Cyl 4.3 L FLEX, 6 Cyl 4.3 L GAS, 8 Cyl 5.3 L FLEX, 8 Cyl 5.3 L GAS, 8 Cyl 5.3 L MILD HYBRID EV-GAS (MHEV), 8 Cyl 6.2 L GAS
| Page 1 of 3 |Next >
1-20 of 53 Results
Chevrolet Silverado 1500 Fuse
Our website offers an extensive catalog of genuine Chevrolet Silverado 1500 Fuse at unbeatable prices. Every OEM Chevrolet Silverado 1500 Fuse comes with a manufacturer's warranty, an easy return policy, and rapid delivery service. Don't miss out on this great opportunity!
Chevrolet Silverado 1500 Fuse Parts Questions & Experts Answers
Q: How to replace the 175 Amp Mega Fuse (Diesel) on Chevrolet Silverado 1500?
A: The first step before replacing the 175 amp mega Fuse (Diesel) is to disconnect the auxiliary battery negative cable. Unscrew the mega Fuse cover and the starter solenoid cable nut together with the terminal from the Fuse stud. Unfasten the auxiliary battery positive cable nut from the mega Fuse holder after disconnecting the generator battery jumper cable to Fuse nut and terminal from the Fuse stud. Disconnection of the auxiliary battery positive cable from Fuse studs requires removal of the appropriate mega Fuse unless the upper mega Fuse nut needs non-sequential removal. After fitting the new mega Fuse install the upper mega Fuse nut when needed by securing it using 15 nm torque (11 lb ft). Tighten all three connections sequentially: first connect the auxiliary battery positive cable to the Fuse studs then install the generator battery jumper cable terminal to the Fuse stud before securing the generator battery jumper cable to Fuse nut and tighten it to 9 nm (80 lb in). Fasten the auxiliary battery positive cable nut to the mega Fuse holder at 15 nm (11 lb ft) then install the starter solenoid cable terminal with its nut to the Fuse stud at 15 nm (11 lb ft). Put back the mega Fuse cover and return power through the auxiliary battery negative cable.