Other Name: Pad, Front Center Seat Cushion; Pad, Seat Cushion; Seat Cushion
Position: Front Center
Warranty: This genuine part is guaranteed by GM's
factory warranty.
Fits the following Vehicles:
2007 Chevrolet Silverado 3500 Classic | LS, LT, WT | 8 Cyl 6.0 L GAS, 8 Cyl 6.6 L DIESEL, 8 Cyl 8.1 L GAS
Chevrolet Silverado 3500 Classic Seat Cushion Pad
Our website offers an extensive catalog of genuine Chevrolet Silverado 3500 Classic Seat Cushion Pad at unbeatable prices. Every OEM Chevrolet Silverado 3500 Classic Seat Cushion Pad comes with a manufacturer's warranty, an easy return policy, and rapid delivery service. Don't miss out on this great opportunity!
Chevrolet Silverado 3500 Classic Seat Cushion Pad Parts Questions & Experts Answers
Q: How to replace the Seat Cushion Pad and trim cover on Chevrolet Silverado 3500 Classic?
A: Start by removing front seat nuts under the blanket before progressing to disassemble the front seat trim panel. The lumbar wire harness needs removal through disconnection and the lumbar cable needs unsnapping when power lumbar is equipped. Start by disconnecting electrical connectors before removing the pressure sensor when necessary from the front passenger seat frame. Pull forward the seat cushion after lifting it off its rear plastic holders. Disassemble the seat switch bezel and the lumbar actuator followed by unclipping the seat trim cover off the seat cushion frame. The seat cushion pad separation from the trim cover must be performed using side-to-side movements. The passenger presence system requires replacement as a unified complete assembly because the bladder and pressure sensor with seat cushion along with control module operate as calibrated units. A front passenger seat cushion replacement requires complete replacement of the Inflatable Restraint Passenger Presence System. The pad requires removal from the seat frame along with any present seat heating element. Installation requires first placement of seat cushion heater elements (if available) followed by Inflatable Restraint Passenger Presence System assembly. Begin by attaching the seat cushion pad to its frame. Then pull the seat cushion cover onto the frame pad while working from side to side. The seat trim cover attaches to the seat cushion frame before adding the lumbar actuator and the seat switch bezel. Slide the cushion onto the rear plastic mounts before pushing it towards the back. When power lumbar is available the installation process starts with cable and harness connection but pressure sensors only need installation when applicable. After reconnecting all electrical cables, attach the front nuts onto the studs under the cushion's bottom section and achieve 21 N.m (15 lb ft) of torque on each nut. To finish the installation place the front seat trim panel and reset the Inflatable Restraint Passenger Presence System to zero position.