Begin replacing the engine Flywheel by removing the automatic transmission while paying attention to the orientation of the engine Flywheel during extraction. The next step involves removing all engine Flywheel bolts before taking away the automatic transmission engine Flywheel. Two m11x1.5 mm bolts can be inserted into the spacer threaded holes at the
Crankshaft rear before they are detached by rotating them clockwise. Position the spacer on the Crankshaft rear before installing the automatic transmission engine Flywheel to the Crankshaft. Longer Flywheel bolts should always be used when installing a spacer between the automatic transmission engine Flywheel and Crankshaft. Knowledge-based formula gm p/n 12345382, canada p/n 10953489 matches another available product which should be applied onto Flywheel bolt threads. The engine Flywheel bolt installation should follow a sequential process of torquing each bolt to 20 nm (15 ft. Lbs.) followed by 50 nm (37 ft. Lbs.) and ending at 100 nm (74 ft. Lbs.). You must reinstall the automatic transmission after finishing the installation process.