First, lift up and support your vehicle (vehicle) and turn a tire and wheel assembly. Then, remove the brake rotor and remove the hub with the bearings and seals. Then disconnect the 4 bolts that hold the Brake Dust Shields to the Spindle and take off the Brake Dust Shields from the Spindle. For installation, bolt the Brake Dust Shields to the Spindle, using following fastener notice in service precautions, and install the four bolts to the Brake Dust Shields, tightening to 50nm (36.5 ft. Lbs.). Replace the wheel hub, the bearings, the seals, the brake rotor and the tire and wheel assembly. Finally, reduce the vehicle and check wheel balancing, adjusting it if needed.