Other Name: Receiver Assembly-Remote Control Door Lock; Receiver, Door Lock Remote Control Inside; Receiver, Door Electric And Vacuum Locks; Module, Tire Pressure
Replaces: 25856316, 25938218
Warranty: This genuine part is guaranteed by GM's
factory warranty.
Fits the following Vehicles:
2021-2023 GMC Savana 2500 | Base, LS, LT | 4 Cyl 2.8 L DIESEL, 6 Cyl 4.3 L FLEX, 6 Cyl 4.3 L GAS, 8 Cyl 6.6 L GAS
Warranty: This genuine part is guaranteed by GM's
factory warranty.
Fits the following Vehicles:
2016-2023 GMC Savana 2500 | Base, LS, LT | 4 Cyl 2.8 L DIESEL, 6 Cyl 4.3 L FLEX, 6 Cyl 4.3 L GAS, 8 Cyl 4.8 L FLEX, 8 Cyl 6.0 L CNG, 8 Cyl 6.0 L FLEX, 8 Cyl 6.0 L GAS, 8 Cyl 6.6 L DIESEL, 8 Cyl 6.6 L GAS
GMC Savana 2500 TPMS Sensor
Our website offers an extensive catalog of genuine GMC Savana 2500 TPMS Sensor at unbeatable prices. Every OEM GMC Savana 2500 TPMS Sensor comes with a manufacturer's warranty, an easy return policy, and rapid delivery service. Don't miss out on this great opportunity!
GMC Savana 2500 TPMS Sensor Parts Questions & Experts Answers
Q: How to replace the TPMS Sensor on GMC Savana 2500?
A: During sensor replacement start by elevating the vehicle on appropriate supports. Separate the tire/wheel assembly from the vehicle's chassis. Before taking off the tire you should set the sensor's cap and nickel-plated valve on a clean platform because aluminum caps and nickel-plated valves guard against corrosion. The sensor installation requires only authentic materials that must never be replaced by alternatives. During tire bead separation from the wheel use the bead breaking fixture at a 90-degree angle from the valve stem and carefully insert a tire iron or pry bar slightly clockwise beside the sensor body before lifting the tire bead over the mounting or dismounting head. Apply the tire machine to rotate the tire/wheel assembly by the clockwise method during the bead transfer process to the wheel rim edge both for inside and outside beads. Remove the tire from the wheel then work to remove all tire sealant residue from its interior surfaces. The independent procedure starts with sensor nut removal followed by sensor removal. Installation requires cleaning the grommet sealing surface before placing the sensor rod inside the wheel hole with air flow directed away from the wheel butted next to the wheel's interior surface before torquing the sensor nut to 7 Nm (62 lb in). To install the tire properly place the mounting/dismounting head at 180° distance from the valve stem while setting the bead transition area 45° counterclockwise from the valve stem before you rotate the tire/wheel assembly clockwise to move the tire beads into the wheel rim cavity. Repeat this process for the outer bead. The service replacement tire pressure sensor requires spinning above 32 km/h (20 mph) for at least 10 seconds to operate correctly because it ships in an OFF mode. Once the internal roll switch is activated the wheel installation can proceed. Following sensor initialization, install the tire/wheel assembly and let the vehicle lower itself before sensor learning proceeds.