Other Name: Switch, Air Conditioner Compressor; A/C Cut-Out Switch; HVAC Pressure Switch; System Switch; Pressure Cycling Switch; Switch, A/C Electric Temperature And Motor Control; Switch, A/C Compressor (Internal Parts)
Warranty: This genuine part is guaranteed by GM's
factory warranty.
Fits the following Vehicles:
2000-2008 GMC Savana 3500 | Base, LS, LT, SLE, SLT | 6 Cyl 4.3 L GAS, 8 Cyl 4.8 L GAS, 8 Cyl 5.7 L BI-FUEL, 8 Cyl 5.7 L GAS, 8 Cyl 6.0 L CNG, 8 Cyl 6.0 L GAS, 8 Cyl 6.5 L DIESEL, 8 Cyl 6.6 L DIESEL, 8 Cyl 7.4 L GAS, 8 Cyl 8.1 L GAS
Other Name: Air Conditioner Refrigerant Pressure Sensor Assembly; Pressure Sensor; High Pressure Thermostatic Switch; A/C Temp & Motor Sensor; Compressor & Evaporator Sensors
Warranty: This genuine part is guaranteed by GM's
factory warranty.
Fits the following Vehicles:
2021-2024 GMC Savana 3500 | Base, LS, LT | 4 Cyl 2.8 L DIESEL, 6 Cyl 4.3 L FLEX, 6 Cyl 4.3 L GAS, 8 Cyl 6.6 L GAS
GMC Savana 3500 A/C Compressor Cut-Out Switches
Our website offers an extensive catalog of genuine GMC Savana 3500 A/C Compressor Cut-Out Switches at unbeatable prices. Every OEM GMC Savana 3500 A/C Compressor Cut-Out Switches comes with a manufacturer's warranty, an easy return policy, and rapid delivery service. Don't miss out on this great opportunity!
Q: How to replace the A/C Compressor Cut-Out Switches on GMC Savana 3500?
A: The process of changing the A/C high pressure cut-out switch requires removal of the engine cover as a first step. Perform the refrigerant recovery procedure with the Refrigerant Recovery and Recharging System (J 39500-B). Wipe down the control switch area first and proceed to remove its snap ring before eliminating the electrical connector from the switch positioned at the back of the compressor head. The switch can be removed from the compressor with the help of snap ring pliers (J 5403) after taking out the switch snap ring. The O-ring remover (J 9553-01) must be used to replace the worn O-ring seal inside the switch cavity while the cavity and O-ring groove receive a cleaning for any presence of foreign materials. Reinstall the existing control switch by using the new O-ring and retaining ring that accompanies a new switch kit. The switch cavity should receive a new O-ring which requires 525 viscosity refrigerant oil lubrication before installing the O-ring into its groove. Apply 525 cleanliness oil to the control switch housing before inserting the switch into the cavity and letting it reach the bottom position. Employ snap ring pliers (J 5403) to set the switch snap ring while positioning the highest point of the curve opposite the switch housing and ensuring complete groove insertion. Rephrase the next steps using Refrigerant Recovery and Recharging System (J 39500-B) and check for leaks before putting back the engine cover.