GM 15783028
Trailing Arm Bracket, Green Line, Rear Driver Side

Raising and supporting the car to replace the rear axle of control trailing arm as well as to replace the rear suspension control arm bracket. Serve to remove the tire and wheel assembly. Next, remove the park brake cable retaining bolt and bracket from the trailing arm . Use the right tool to remove the park brake retaining clip from the trailing arm bracket . However, you disconnect the trailing arm knuckle bolts and remove the trailing arm bracket. Also remove the trailing arm and the bracket from the frame and the knuckle, as well as the bolt and nut at the trailing arm to the trailing arm bracket. For installation, the first step is to install the bolt and nut from the trailing arm bracket at the trailing arm, as you will tighten the trailing arm to bracket nut at 60N.m (44 lb.ft) and you will use the J 45059 Angle Meter (J 45059) to rotate the nut by an additional 60°. Mount the trailing arm and bracket assembly to the Knuckle as well as to the frame followed by the tightening of the bolts from the trailing arm to the knuckle to be 180 N.m (133 lb ft). Fasten the mounting bolts of the trailing arm bracket with 60 N.m (44 lb ft) and an additional rotation of 60° using the J 45059 Angle Meter (J 45059). Then, install the park brake cable retaining clip to the trailing arm bracket , park brake cable retaining bracket and bolt to the trailing arm , tighten the mounting bolt to 10 N.m (89 lb in). Lastly, reinstall the tire and wheel assembly and return the vehicle to the ground.

Reinstall the tire and wheel assembly and lower the vehicle.

Remove the lower control arm from the bracket, taking note of the position of the spacer on the front bushing.