GM 15801722
Cable

To replace the radio antenna cable, its extension cable, you shall first remove the inflatable restraint instrument panel (I/P) module. Before you remove the antenna cable locate the radio extension cable, disconnect the cable from the radio extension cable. Pull off the cable attachments from the I/P support bars, then access through the I/P compartment and pull off the antenna cable from the radio. Pull the radio extension cable out of the vehicle. For installation, locate the radio extension cable to the I/P support bars as mentioned earlier, and then extend a hand into the I/P compartment with the radio to connect the antenna cable to the radio. Mount the radio extension cable attachments to the I/P support bars, and mount the antenna cable to the radio extension cable. Finally, there is the installation of the Inflatable restraint module.

To replace the mobile telephone antenna coaxial cable, first turn the ignition of to the off position and then take out the right rear seat cushion. Next, remove the communication interface module and the navigation control processor bracket. Sheath the cellular telephone coax cable through the carpet opening and remove seat back on both the left and right sides, front and rear door sill plates, center pillar trim panels, rear quarter upper and lower rear quarter trim panels. Take off the left coat hook, toolkit carriers, and child restraint tether anchors, and then raise and fold carpet covering bucket seats. Remove the coax cable fasteners from the floor panel and left third pillar, and remove the coax cable from the window mounted coupling. To install, connect the coax cable to the window installed coupling, replace the coax cable fasteners to the left third pillar and floor panel, and place the carpet back to the floor panel in line with seat studs. Mount the child restraint tether anchors and the tool kit carrier, and fasten the 3 tool carrier nuts to the floor studs with a torque of 7.0 nm (62 lb in). Replace the lower rear quarter trim panels, rear quarter upper trim panels, center pillar trim panels, left coat hook and rear door sill plates and the front door sill plates. Lastly, replace the seat back on both sides, navigation control processor bracket, communication interface module, and the right rear seat cushion in a passenger's position.

The seat back on both the left and right sides, front and rear door sill plates, center pillar trim panels, rear quarter upper trim panels, lower rear quarter trim panels, left coat hook, tool kit carrier, and child restraint tether anchors.

Pass the antenna cable and grommet assembly through the fender opening and remove the radio antenna cable assembly.

Attach the coaxial cable to the right windshield pillar.

Detach the coaxial cable from the right windshield pillar and lower the right closeout insulator panel.

Open the instrument panel (I/P) compartment fully and disconnect the radio antenna cable from the radio extension cable.

Pass the end of the radio antenna cable assembly through the cowl opening and remove the antenna mast.

Remove the cable attachments from the I/P support bars.