GM 15752576
Antenna Cable

The coaxial cable requires two steps. Start by removing the Antenna mast before disconnecting the radio Antenna Cable from the radio extension cable. Start by removing the fender and then the radio Antenna Cable nut and radio Antenna bezel. Initially remove the screws holding the radio Antenna Cable into place before pulling out the cable. Begin installation by mounting the new radio Antenna Cable following screw installation until torque reaches 2.8 n.m (25 lb in). Place the radio Antenna bezel first and tighten the radio Antenna Cable nut to 6 n.m (53 lb in). The installation process begins by securing the fender in place followed by cable connection of the radio Antenna to the radio extension cable and ends with mast Antenna placement.

Start by removing the Antenna mast before you disconnect the radio Antenna Cable from the radio extension cable. Start by removing the fender and proceed to the radio Antenna Cable nut removal before taking off the radio Antenna bezel. You need to unscrew the radio Antenna Cable attachment screws before extracting the cable from its position. During installation first install the new radio Antenna Cable making sure to tighten the radio Antenna Cable screws to 2.8 n.m (25 lb in). Next install the radio Antenna bezel followed by the radio Antenna Cable nut which should be tightened to 6 n.m (53 lb in). After attaching the fender piece you should connect the radio Antenna Cable to the radio extension cable before replacing the Antenna mast as the last step.

Start Antenna Cable service and repair work by removing the Antenna mast followed by disconnecting the radio Antenna Cable from the radio extension cable. Start by removing the fender after which the technician removes the radio Antenna Cable nut and the radio Antenna bezel before securing the radio Antenna Cable with screws. Fitting a new radio Antenna Cable requires screw tightening forces of 2.8 n.m along the radio Antenna Cable screws to 2.8 n.m (25 lb in). After installation of the radio Antenna bezel move onward to attach the radio Antenna Cable nut while tightening it to 6 n.m (53 lb in). You must first install the fender before connecting the radio Antenna Cable to the radio extension cable while reattaching the Antenna mast.

Begin by removing the Antenna mast followed by disconnecting the radio Antenna Cable from its connection to the radio extension cable. To start remove the fender then unfasten the radio Antenna Cable nut and radio Antenna bezel. Begin by disassembling the radio Antenna Cable through removal of its mounting screws before extracting the cable. Secure the new radio Antenna Cable with screws then tighten each screw to 2.8 n.m (25 lb in). After nutting down the radio Antenna Cable with a torque of 6 n.m to 53 lb in. After reinstalling the fender complete the process by connecting the radio Antenna Cable to the radio extension cable then reinstalling the Antenna mast.