GM 19208223
Headlamp Assembly, Passenger Side

Replacing either the headlamp assembly or headlamp bulb (HID) requires you to extract the front grille followed by removing headlamp retainer pins and then drawing out the headlamp assembly in order to disconnect the electrical connector. Access to the headlamp bulbs becomes possible by first removing the rubber cups. Begin by installing the new bulbs before putting on the rubber cups for installation. The electrical connector ties to the lamp assembly first while replacing the lamp assembly back to its position in the vehicle by using headlamp assembly retainer pins before securing the front grille. Be vigilant about the high voltage and current operations of the high intensity discharge system since opening the ballast or arc tube assembly or probing between electrical connectors causes severe shocks and burns. Maintain safe distances between the arc tube and the headlamp housing as well as bulb shield when uninstalling or installing to prevent any damage from occurring.

Replacing either the headlamp assembly or headlamp bulb (HID) requires you to extract the front grille followed by removing headlamp retainer pins and then drawing out the headlamp assembly in order to disconnect the electrical connector. Access to the headlamp bulbs becomes possible by first removing the rubber cups. Begin by installing the new bulbs before putting on the rubber cups for installation. The electrical connector ties to the lamp assembly first while replacing the lamp assembly back to its position in the vehicle by using headlamp assembly retainer pins before securing the front grille. Be vigilant about the high voltage and current operations of the high intensity discharge system since opening the ballast or arc tube assembly or probing between electrical connectors causes severe shocks and burns. Maintain safe distances between the arc tube and the headlamp housing as well as bulb shield when uninstalling or installing to prevent any damage from occurring.

To replace the headlamp bulb, the front grille has to be removed followed by removing the headlamp retainer pins, after which the headlamp assembly can be exerted to reach the electrical connector and disconnect it. Then, remove the rubber cup to access the headlamp bulbs and pull out the bulbs. When fitting the new bulbs, remember to replace a high beam bulb with another high beam bulb which has a red gasket and the low beam bulb another low beam bulb that has a gray tip and yellow gasket on its base. Place rubber cup back, reconnect the electrical connector to the lamp assembly, reinstall the lamp assembly into the vehicle, and secure headlamp assembly with the retainer pins, and finally reinstall the front grille.